Connecting devices

This standard applies to devices for the connection of luminaires (DCL) intended for household and similar purposes, for the electrical connection of fixed luminaires of class I or class II to final circuits rated at not more than 16 A without providing a mechanical support for the luminaire. (Published Document (JS))

This part of IEC 61995, which is to be read in conjunction with IEC 61995-1, applies to devices for the connection of luminaires (DCL) 250 V, 6 A a.c. intended for household and similar purposes, for the electrical connection to final circuits rated not more than 16 A, without providing mechanical support for the luminaire. (Published Document (JS))

This standard applies to PT systems which are intended to be mounted on, or under the floor level and floor service units which are mounted on the floor, under the floor or flush with the floor. (Published Document (JS))

This standard applies to connecting devices as separate entities for the connection for two or more electrical copper conductors ( complying with IEC 60228 or IEC 60344) rigide (soild or standard) or flexible having a cross-sectional area of 0.2 mm up to and including 1 000 Hz and 1 500 V d.c (Published Document (JS))

This standard applies to connecting devices with insulation piercing clamping units primarily suitable for connecting insulated unprepared conductor (Published Document (JS))

This standard applies to connecting devices with screwless-type clamping units primarily suitable for connecting unprepared conductors. (Published Document (JS))

This standard applies to connecting devcies with screw-type clamping units primarily suitable for connecting unprepared conductors (Published Document (JS))

This standard applies to the following track systems with two or more poles for the connection of liminaries of the electrical supply consisting of either. (Published Document (JS))

This standard is applicable to two-pole appliance couplers for a.c. only, with or without earthing contact, with a rated voltage not exceeding 250 V and a rated current not exceeding 16 A, for household and similar general purposes and intended for incorporation or integration within electric appliances. (Published Document (JS))

This standard applies to conversion adaptors intended mainly for industrial use, comprising a housing of insulating material which incorporates an industrial. (Published Document (JS))

This stadard Specifices the general requirements and tests to track systems capacity hard to not more than 277 volts for alternating current single phase and 480 volts for direct current two-or three-phase 50/60 Hz frequency and stream no more than 63 mA (Published Document (JS))

This part of JS 60999 applies to screw-type and screwless-type clamping units for connecting devices, either as separate entities or as integral parts of equipment, for the connection of electrical copper conductors (complying with JS 60228), rigid stranded and/or flexible, having a cross-section above 35 mm2 and up to and including 300 mm2 (Published Document (JS))

This standard applies to screw-type and clamping units for connecting devices, either as separate entities or as integral parts of equipment, for the connection of electrical copper conductors,rigid and/or flexible,having a cross-sectional area of 0.2mm2 up to and including 35 mm2 and equivalent AWG sizes ith a rated voltage not exceeding 1000 V a.c. withe a frequency up to 1000 Hz and 1500 Vd.c. (Published Document (JS))

This standard specifies the particular requirements and tests for PT systems intended for mounting on walls and/or ceiling. They may be installed flush or semi-flush, surface mounted, suspended or spaced away from the surface using fixing devices. (Published Document (JS))

This standard applies to the following track systems with two or more poles for the connection of luminaires to the electrical supply of, either (Withdrawn Document)

This standard specifies requirements for metallic non-metallic and composite cable ties and their associated fixing devces used for the management and support of wiring systems in electrical installations up to and including AC 1000 V or DC 1 500 V. (Published Document (JS))