Wires

This standard applies to PT systems which are intended to be mounted on, or under the floor level and floor service units which are mounted on the floor, under the floor or flush with the floor. (Published Document (JS))

This standard specifies the particular requirements and tests for PT systems intended for mounting on walls and/or ceiling. They may be installed flush or semi-flush, surface mounted, suspended or spaced away from the surface using fixing devices. (Published Document (JS))

This stadard Specifices the general requirements and tests to track systems capacity hard to not more than 277 volts for alternating current single phase and 480 volts for direct current two-or three-phase 50/60 Hz frequency and stream no more than 63 mA (Published Document (JS))

This standard is applicable to aluminium-magnesium-silicon alloy wires of two types a & b having different mechanical and electrical properties for overhead power transmission purpoese of wires in the diameter range 1,50 mm to 4,50 mm. (Published Document (JS))

Concerns round wire concentric lay over headelectrical standed conductors (Published Document (JS))

Concerns aluminium strandedconductors used in overhead lines for energy transmission (Withdrawn Document)