Welding equipment

This part of standard 60974 specifies safety and construction requirements for torches for arc welding and allied processes. In this standard a torch consists of the torch body, the cable-hose assembly and other components. It does not apply to electrode holders for manual metal arc welding or torches for air-arc cutting/gouging. (Published Document (JS))

This part of JS 60974 specifies safety and performance requirements for gas consoles intended to be used with combustible gases or oxygen. These gas consoles are designed to supply gases for use in arc welding, plasma cutting, gouging and allied processes in non-explosive atmospheres. (Published Document (JS))

This part of standard 60974 is applicable to electrode holders for manual metal arc welding with electrodes up to 10 mm in diameter. The JS 60974-11 specifies safety and performance requirements of electrode holders. It is not applicable to electrode holders for underwater welding. (Published Document (JS))

This part of JS 60974 is applicable to power sources for arc welding and allied processes designed for industrial and professional use, and supplied by a voltage not exceeding that specified in Table 1 of IEC 60038, or driven by mechanical means. (Published Document (JS))

This part of standard 60974 is applicable to coupling devices for cables for welding and allied processes designed for connection and disconnection without using tools. This part 60974 specifies safety and performance requirements of coupling devices (Published Document (JS))

This part of standard 60974 is applicable to power sources with a thermal cut-out device for manual metal arc welding with limited duty. These welding power sources are mainly used by laymen. This standard specifies safety requirements for construction and performance requirements of welding power sources, limited to a rated maximum welding current of 160 A. (Published Document (JS))

This standard applies to equipment for resistance welding and allied processes (Published Document (JS))

This standard determines requirements of rubber hoses used for welding,cutting and allied processes .For hoses working under pressure normal 20 bar and light 10 bar, and for those working at tempeerature from -20 to +60 c (Published Document (JS))

Concerns flexible hoses used in gas welding, cutting, fusion andmining (Withdrawn Document)