|
JS 811-2:2010 Rigid polyurethane (PUR) foam in slab form Part 2: Specification for PUR foam for use in refrigerators cabinets, cold rooms and stores
This Part of JS 811-2 specifies requirements for thecomposition, physical properties and dimensional tolerances of rigid polyurethane (PUR) foam in the form of slabs (blocks, boards and sheets) for the thermal insulation of refrigerator cabinets (domestic and commercial), cold rooms and cold stores.
(Published Document (JS))
|
|
JS 515:2008 Plastics - Determination of the melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of thermoplastics
This standard specifies two procedures for the determination of the melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of thermoplastic materials under specified conditions of temperature and load. One is a mass-measurement method. The other is a displacement-measurement method.
(Published Document (JS))
|
|
JS 515:2002 Plastics - Determination of the melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of thermoplastics
Concerns the determination of the melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of thermoplastics
(Withdrawn Document)
|
|
JS 926:2002 Plastics – Thermoplastic polyester (TP) moulding and extrusion materials - Preparation of test specimens and determination of properties
Concerns thermoplastics polyester (TP) moulding and extrusion materials Preparation of test specimens and determination of properties
(Published Document (JS))
|
|
JS 926:1993 Plastics - Polyalkylene terephthalates- Preparation of test specimens and determination of properties
Concerns thedetermination of properties and preparation of test specimens ofpolyethylene terephthalates
(Withdrawn Document)
|
|
JS 515:1987 Plastics - Determination of the meltflow rate of thermoplastics
Specifies a method for the determination of the meltmass-flow rate (MFR) and the melt volume-flow rate (MVR) ofthermoplastic materials under specified conditions of temperature andload
(Withdrawn Document)
|
