Aluminium products

Search Results
JS 380-3:2013 Wrought aluminium and aluminium alloys - Extruded rods/bars, tubes and profiles Part 3 : Extruded rectangular bars - Tolerances on shape and dimensions

0 (Committee Draft (CD))

JS ISO 380-2:2013 Wrought aluminium and aluminium alloys ـ Extruded rods/bars, tubes and profiles Part 2 : Mechanical properties

0 (Committee Draft (CD))

JS ISO 380-1:2013 Wrought aluminium and aluminium alloys - Extruded rods/bars, tubes and profiles Part 1: Technical conditions for inspection and delivery

0 (Committee Draft (CD))

JS 380-4:2012 Wrought aluminium and aluminium alloys Extruded rods/bars, tubes and profiles Part 4: Extruded Profiles-Thickness Tolerances on shape and dimensions

0 (Withdrawn Document)

JS 10194:2007 Aluminium and aluminium alloys - Wrought products - Special requirements for products intended for the production of pressure equipment

This standard specifies particular requirements and testing procedures applicable to wrought aluminium and aluminium alloyys intended for the production of pressure equipment. (Published Document (JS))

JS 10027-6:2007 Lighting columns Part 6: Requirements for aluminium lighting columns

This standard specifies requirements for aluminium lighting columns.It includes materials and conformity control. Its specifies performance related to the essential requirements of resistance to horizontal (wind) load and performance under vehicle impact in support of the essential requirement no4 safety in use measured according to the corresponding test (Published Document (JS))

JS 380-4:2004 Wrought aluminium and aluminium alloy extruded rods/bars, tubes and profiles Part 4- Extruded profiles - Tolerances on shape and dimensions

This standard specifies among other things the tolerances on cross-sectional dimensions, on lengths, on the permissible contour and angular, twist, flatness tolerances. The tolerances apply to extruded profiles with cross-sectional dimensions given by a circumscribing circle not greater than 600 mm. This part does not apply to rolled and drawn profiles and profiles made from sheet by roll (Published Document (JS))

JS 380-5:2004 Wrought aluminum and aluminum alloy extruded rods / bars, tubes and profiles part 5: Extruded round, square and hexagonal bars - Tolerances on shape and dimensions

this standard specifies the standards test methods for the tolerances on shape and dimensions for aliminuim products. (Published Document (JS))

JS 379:1997 Aluminium and aluminium alloys - Drawn round bars - Tolerances

Includes tolerances on shape and dimensions (symmetric plusand minus tolerances on diameter) for drawn round bars of wroughtaluminium and aluminium alloys (Published Document (JS))

JS 759:1991 Aluminium - Aluminium coiled strip foils cold-rolled with a thickness of (7-20) micrometer - Dimensions

Concerns thedimensions of cold-rolled aluminium coiled strip foils of 7-20micrometer thickness (Published Document (JS))

JS 292:1991 Aluminium - Properties of aluminium for architectural purposes

Specifies chemical composition, thickness,oxide-film thickness and hardness of aluminium bars used forarchitectural purposes (Withdrawn Document)

JS 444:1986 Aluminium - Wrought aluminium and aluminium alloy products - General conditions for inspection and delivery

Includes the general conditions for inspection and delivery ofwrought aluminium and its alloys (Published Document (JS))

JS 380:1984 Aluminium - Wrought aluminium andaluminium alloys - Extruded round bars - Tolerances on shape anddimensions

Specifies tolerances on shape and dimensions for extruded roundbars of wrought aluminium (Withdrawn Document)